Harvest Time Centerpiece

Pattern Compliments Of:

Suzanne Moore's NC Basket Works
130 Main St. • Post Office Box 744
Vass, NC 28394-0744
910-245-3049 • 800-338-4972
Fax: 910-245-3243
Email: suzanne@ncbasketworks.com
Website: www.ncbasketworks.com


Basket Size: 10 1/2" Diameter x 4" Tall


Materials
9" Round Base
11/64" Flat Oval - weavers & lashing
1/2" Flat Flat - spokes
1/2" Flat Oval - rims
7mm Flat Flat - rim row


Seagrass - rim filler
1/4" Flat Flat dyed rust - weavers
1/4" Flat Flat dyed walnut - weavers
3/8" Maple Basket Strips - curls
1/2" Walnut Basket Strips - weavers


A complete Kit is also available @ $19.95  Kit
(display items not included)


Cut 30 spokes from 1/2" FF each 8" long. If the groove in your base is too narrow to insert the spokes, run sandpaper around the groove several times, and/or sand down the ends of each spoke (you want a tight fit). Insert all spokes into the base, spacing them evenly. Weave 2 rows 11/64" FO start and stop, keeping the spokes FLAT. Then gently upset the spokes and weave 2 more rows 11/64" FO (for a total of 4 rows).

Weave start and stop the follow rows:
1 row 1/4" FF dyed walnut
1 row 1/4" FF dyed rust
1 row 11/64" FO
2 rows 1/2" walnut basket strips
1 row 11/64" FO
1 row 1/4" FF dyed rust
1 row 1/4" FF dyed walnut
3 rows 11/64" FO
1 row 7mm FF (rim Row)

Pack well, cut and tuck spokes. Rim with 1/2" FO, seagrass between rims, and lash with 11/64" FO.

Maple Curls: Soak in warm water for about 1 minute, then put into a plastic bag to "mellow" for about 15 minutes. I found the maple was easier to work with by cutting into 3 shorter pieces. Insert the end of the strand behind a vertical spoke, give a slight twist and insert the end behind the vertical spoke in the row below. Continue around the basket working up and down. Refer to photo.

Spray with Weaver's Stain - I used Clear.


All materials to make this basket are available at NC Basket Works.

Copyright © 2000-2011 NC Basket Works. All rights reserved.
Website design by Timothy Moore. Website maintained by Jim Moore   Jim@ncbasketworks.com